Control Elements For Remote Control App; Initial Connection Between Remote Control App And Prosthesis - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

Remote control app
Android from version 4.0.3 (older versions are not supported)

9.2 Control elements for remote control app

9.3 Initial connection between remote control app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on.
If Bluetooth is switched off, it can be switched on either by rotating the prosthesis or connecting/disconnecting
the battery charger. Bluetooth is then switched on for approx. 2 minutes. During this time, the app must be
started and used to establish a connection. If desired, the Bluetooth of the prosthesis can then be permanently
switched on (see Page 86).
• Bluetooth of the device must be switched on.
The device may not be in flight mode.
• The device must be connected to the internet.
• The serial number of the component you want to connect to is required. For knee joints, this is located on the
inside of the frame and begins with the letters "SN".
• The PIN code of the component is required.
76 | Ottobock
1. Product name
The component name can only be changed with the adjustment soft­
ware.
If connections to a number of prostheses have been saved, you can
switch between the saved prostheses by tapping on their names.
2. Query status (see Page 77)
3. Bluetooth of the component switched on
Further information about switching Bluetooth off/on see Page 86.
4. Call up extended menu (see Page 77)
5. Currently selected mode and MyModes configured with the adjustment
software.
Switching the mode by tapping the corresponding symbol and confirm­
ing by tapping "OK".
6. Change settings of the currently selected mode (see Page 84).
7. Charge level of the component.
Component battery fully charged
Component battery empty
The current charge level is also displayed in %.
8. Connection to component has been established
Connection to component has been interrupted. The app is attempt­
ing to re-establish the connection automatically.
9. Additional display of the currently selected mode
C-Leg 3C98-3/3C88-3