Setting Device Properties For Analog Input Modules - Ametek FlarePro User Manual

Setting Device Properties for Analog Input Modules

Figure 6-8.
General tab, Device
Properties screen.
6-14 | FlarePro Process Mass Spectrometer
1. From the 2000 Software, click the Edit menu and select Device
Properties (Figure 6-2). Select your Opto 22 SNAP I/O System device
from Select a device to edit. Click OK. The Device Properties dialog
box (Figure 6-8) appears.
If an analog device is not listed, click Cancel. On the main screen click
the Edit menu and Add Device. Click Optomux Analog. Once the
analog module has been added, you can proceed with setting the
parameters.
2. From the General tab configure the Communications parameters as
follows:
• Bits per Second:
• Address:
• Type: Optomux Analog
3. Make sure Device enabled and Live data boxes are checked.
Older I/O systems had a single analog input or output per
module. The SNAP I/O system combines four inputs or outputs
into one module. For the SNAP I/O system, the Process 2000
module number refers to a particular analog I/O channel, not the
physical module. For example, if a single analog output module is
installed in the first SNAP rack position, the Process 2000 will
refer to it as Modules 0 and 1. See B3000 I/O Mapping and
Example in this chapter.
57,600
130