Transportation/Setting-Up - Ametek Spectro MIDEX Original Operating Instructions

Transportation / Setting-up
4 Transportation / Setting-up
Only instructed personnel may transport, unpack, install, and start up the
instrument.
Information: Measurement errors!

Shocks to the instrument during the measuring process may result in
measurement errors.



Measurement errors may result from temperature differences inside the
instrument.

Notice! Damage to instrument
If the instrument is to be moved to another place of installation after set-up, there
is a risk of damaging the instrument. Contact the SPECTRO Service Department
in this matter.
Compliance with the following information is required regarding the instrument's
transport and setup:

Always transport the instrument in a horizontal position, ensuring its legs are
pointing down. Always have two persons transport the instrument! To this
end, use both of your hands to reach underneath the housing.

Avoid mechanical impacts.

Save the shipping box in case you have to ship the instrument to the service
department at a later date.

All connections are located at the rear side.

Set up the instrument to ensure the power isolators (switches and power
cable) can be easily reached.

When setting up the instrument, ensure that all sides are easy to access
for maintenance, repair and connection/disconnection purposes.

All necessary cables are included in the delivery.
— 12
Therefore, shocks to the instrument when taking measurements must
be avoided.
Avoid mechanical impacts.
Install the instrument so that it cannot heat up on one side only.
SPECTRO MIDEX — 05.10.2017