Figure 6-12.
Scan tab, Device
Properties screen.
Figure 6-13.
Display tab, Device
Properties screen.
6-16 | FlarePro Process Mass Spectrometer
a. From the Scan tab (Figure 6-6), click Device and select your analog
input device.
b. From the Display tab (Figure 6-13) configure the parameters for the
display.
c. Click OK for it to become part of the mode display you have chosen.
Digital and Analog Outputs
• Refer to Chapter 8 in the 2000 software manual for setting up the
Digital Outputs.
• Refer to Chapter 9 in the 2000 software manual for setting up the
Analog Outputs.