Chapter 5 Board Replacement - Ametek FlarePro User Manual

Scan Board
Figure 5-1.
Electronics unit board
locations.
BOARD REPLACEMENT
The electronics unit contains six boards (Figure 5-1) that can be replaced
in the field if they become damaged or faulty. These boards can be
replaced using only a #1 Phillips screwdriver and a 1/4" nut driver. The
boards are:
• I/O board
Located between the Front Panel and the LED / Heat Sink.
• Master board
Located behind the left front panel on the front of the unit.
• Control board
Located behind the front heat sink and LED panel on the left side.
• Scan board
Located behind the front heat sink and LED panel on the right side.
• Amp board
Located behind the rear heat sink and under the Amp Board Cover.
• RF board
Located behind the rear heat sink and separated from it by the
conductor guide.
Option Plate
Master
Control
Board
Board
RF Board
Amp Board
Small Pattern Kep Nut
Must Be Used
4/40 x 3/16"
Screws
Master Board
4/40 x 1/4"
Screws
Scan Board
Front Heat Sink
Option I/O
Front Panel
Board Slot
Board Replacement | 5-1
Control
Board