Table of Contents
Advertisement
PARAMETER PUMP
P ACCELER. DELAY
P RELEASE BRK
P TILLER BRAKING
P DECEL. BRAKING
P SPD. LIMIT BRK
MIN SPEED LIFT
MAX SPEED LIFT
1ST PUMP SPEED
P MAX.CURR. TRA.
P MAX.CURR. BRK.
HYD PUMP SPEED
P AUXILIARY TIME
P EBRAKE ON APPL
P EB.ENGAGE DEL.
P ROLLING DW SPD
P ACCEL MODULAT.
P STOP ON RAMP
HYDRO TIME
P THROTTLE 0
P THROTTLE X1
P THROTTLE Y1
P THROTTLE X2
P THROTTLE Y2
P THROTTLE X3
P THROTTLE Y3
Page 70/169
SLV SET OPTIONS
SLV ADJUSTMEN
S AUX OUT FUNCT.
SLV ADJUSTMENT
S DIAG.JUMP SENS
AFNZPxxx – DUALACE2 NEW GENERATION – User Manual
SLV HARDWARE
VALVE OUTPUT
EVP TYPE
S TOP MAX SPEED
EVP COIL RESIST.
S FEEDBACK SENS
MIN EVP
S ROT. CW ENC
MAX EVP
S ROT CW MOT
EVP OPEN DELAY
S ENC PULSES 1
EVP CLOSE DELAY
S ENC PULSES 2
DITHER AMPLITUDE
S MOT. P. PAIRS 1
DITHER FREQUENCY
S MOT. P. PAIRS 2
S FEEDBACK SENS
S ROT. CW ENC
S ROT CW MOT
SETTING
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the DUALACE2 NEW GENERATION and is the answer not in the manual?
Questions and answers
Como comprobar el funcionamiento del controlador dualac2 sin display
You can check the operation of the Zapi DUALACE2 NEW GENERATION controller without a display using the following methods:
1. Zapi Smart Console – Connect the Zapi Smart Console to the CAN bus to access diagnostics and parameter settings.
2. PC CAN Console – Use the PC CAN Console software to monitor and adjust controller settings.
3. Self-Diagnosis Feature – The controller performs self-diagnosis, and faults can be displayed using Zapi tools.
4. Alarm History Log – Check the log of alarms to review past faults and system behavior.
5. TESTER Function – Use the TESTER function to monitor key operational readouts.
These methods allow you to diagnose and verify the controller’s operation without an external display.
This answer is automatically generated
A brumby electrical truck that has a zapi inv.dace2, records the failure 244 "Warning Slave It depends on the supervisor uc", and the alarm 248 "Mc is Opened, eb is applied". On the other hand, the LED does not turn on, but in the manual I did not find the LED code. I would like more certainty about whether the failure is from the controller and the LED code for this Zapi model.
Failure 244 "Warning Slave" depends on the supervisor microcontroller (µC). No specific effect or troubleshooting steps are provided in the available context.
Alarm 248 "MC is Opened, EB is Applied" indicates that the main contactor (MC) is open, and the electric brake (EB) is applied. This typically occurs during start-up, standby, or other system states.
The LED code for this model is not explicitly provided in the available context.
This answer is automatically generated