Paper Selection - Canon iR3245 Manual

1

Paper Selection

Remark
For information on the modes which cannot be set in
combination with this mode, see "Combination of
Functions Chart(p.9-2)."
When printing on special types of paper, such as
heavy paper or transparencies, be sure to correctly set
the paper type, especially if you are using heavy paper.
If the type of paper is not set correctly, it could
adversely affect the quality of the image. Moreover, the
fixing unit may become dirty, or the paper could jam,
and a service repair may be needed.
If you are copying an original with an image that
extends all the way to the edges onto the same size
paper at a copy ratio of 100%, the periphery of the
original image may be cut off slightly on the copy.
If you select the Entire Image mode, the copied image
is automatically reduced slightly based on the copy
paper size and the image size. As a result, the entire
original image is reproduced on the copy without being
cut off. (See "Entire Image(p.3-15).")
If you select [Free Size], [Envelope], [Tracing Paper],
[Transparency], or [Labels], you cannot specify any
Finishing modes (Collate, Group, or Staple).
1-24 Paper Selection
If Stack Bypass Standard Settings in Common
Settings (from the Additional Functions screen) is set
to 'On', and the paper size/type have been stored, the
selected paper size/type are displayed on the screen.
(See the Reference Guide.)
For instructions on loading paper into the stack
bypass, see the Reference Guide.
For more information on paper types, see the
Reference Guide.
For instructions on entering values in inches, see the
Reference Guide.