Canon iR3245 Manual page 29

Remark
For information on the modes which cannot be set in
combination with this mode, see "Combination of
Functions Chart(p.9-2)."
If you specify the Form Composition mode with the
Cascade Copy mode, it is necessary to assign the
same name to the stored image form in both this
machine and the remote copy printer beforehand. If the
assigned image form name in this machine is not set in
the remote copy printer, the job is cancelled. If multiple
image forms with the same assigned name are stored
in the remote copy printer, different images may be
used for Form Composition.
If you turn the remote copy printer back ON or reattach
the finisher, you need to refresh the settings of the
remote copy printer in Register Remote Device in Copy
Settings (from the Additional Functions screen). (See
"Confirming a Remote Device(p.8-23).")
If <Use IPv4> in [IPv4 Settings] in [TCP/IP Settings] in
Network Settings in System Settings (from the
Additional Functions screen) is set to 'Off', you cannot
register a remote copy printer. (See the Network
Guide.)
If you connect the machine directly to other remote
copy printers using a crossover patch cord, you must
configure the Ethernet driver as shown below. (See the
Network Guide.)
Auto Detect: Off
Communication Mode:Full Duplex
Ethernet Type: 100 Base-TX
In order for a device to be selected as a remote output
device used for remote copying, it must be stored in
Register Remote Device in Copy Settings (from the
Additional Functions screen). (See "Specifying the
Remote Copy Printer Settings(p.8-20).")
For cascade copying, the Paper Select screen of this
machine is displayed. Select the paper drawer on the
machine that is loaded with the same paper size as the
remote copy printers.
Giving Priority to the Copy Mode (p.1-18)
Giving Priority to the Output Device (p.1-21)
To copy the original on this machine and another
remote copy printer on the network at the same time
(cascade copying), the number of copies set for this
machine are split in half and printed. If an odd number
of copies is set, this machine will print one additional
copy.
If you select a remote copy printer before setting the
copy modes to perform with cascade copying, you
cannot select copy settings that are not supported by
the remote copy printer. Also, if the finishers attached
to this machine and the remote copy printer are
different, the finishing settings can only be set to
Collate and Group modes.
When a remote copy or cascade copy job is in
progress, you cannot reserve another remote copy or
cascade copy job.
For the selected remote copy printer, set the same
Department ID and password as this machine. (See
the Reference Guide.)
When a remote copy or cascade copy job is in
progress, and an error occurs in the remote copy
printer, an error message is displayed on the Job/Print
monitor area of the touch panel display of this machine
and the remote copy printer.
For instructions on cancelling a remote copy or
cascade copy job, see the Reference Guide.
Selecting an Output Device (Select Output Device)
1
1-17