Copying Separately-Set Originals (Job Build) - Canon iR3245 Manual

Copying Separately-Set Originals (Job Build)

For instructions on this procedure using the Regular Copy Basic Features screen, see "Job Build(p.4-43)."
Remark
The 2-Sided Original mode is available only if the
optional Feeder (DADF-U1) is attached
(standard-equipped for the iR3245N/iR3235N/
iR3225N).
You cannot change the copy settings while the
machine is scanning originals in the Job Build mode.
You need to set the necessary copy settings
beforehand, according to the type of originals and the
desired result.
If you place the originals in the feeder, remove each
original from the original output area when scanning is
complete.
1. Press [Scan Originals] → [Job Build].
2. Press [Set].
When copying, you can change or specify the following
settings before scanning the next batch of originals
(i.e., between batches): the number of copies, 2-Sided
Original mode, original type, copy exposure. However,
if you specify the Image Combination mode with the
Job Build mode, you cannot change the original type
and copy exposure.
If you use the Job Block Combination mode, the Job
Build mode is automatically set for each batch of
originals. You cannot use the Job Build mode for the
combined document.
Copying Separately-Set Originals (Job Build)
7
7-53