Co 2 Default Settings - GE CARESCAPE ONE User Manual

CARESCAPE ONE User Manual DRAFT 26 October 2017
Default settings
CO default settings
2
Select Monitor Setup > Main Setup > Parameter Setup > Page 1 > CO2 > Setup to adjust
these settings for the current patient. The following table lists the factory default settings.
Setting Description
Scale % Select the CO
scale.
CO2 Sweep
Select the CO
Speed
sweep speed.
CO2 Average
Select the time
window that is
used to select
the displayed
CO value.
2
FiO2 level % Select the
level of FiO
used to make
compensation
to measured
CO values.
2
N2O level % Select the
level of N
used to make
compensation
to measured
CO values.
2
Select Monitor Setup > Main Setup > Parameter Setup > Page 1 > CO2 > Alarms > Page
1 or Page 2 to adjust these settings for the current patient. The following table lists the
factory default settings.
Setting Description
EtCO alarm Select the
2
limits high/low alarm
limits (%).
FiCO alarm Select the
2
limits high/low alarm
limits (%).
FiCO alarms Enable alarm
2
on/off when limits are
violated.
364
ED
2
2
2
O
2
ED
8/3
(Neuro and Trauma
profiles: 6.0/2.7.)
(OR software package Perfusion profile: Disabled)
CARESCAPE ONE
ICU NICU
0-6
6.25 mm/s
10 s
21-40
0-40
ICU NICU
8/3
Perfusion
profile: 8/0)
3/OFF
Enabled
OR PACU
OR PACU
8/3 8/3
(Neuro (Neuro
profile: profile:
6.0/2.7; 6/2.7)
2094480-001