Spo 2 Default Settings - GE CARESCAPE ONE User Manual

CARESCAPE ONE User Manual DRAFT 26 October 2017
Default settings
Setting Description
Resp Rate
Select the high/low
(Imped.) alarm
alarm limits.
limits
Apnea Limit Select medium
Seconds elapsed time limit.
Cardiac Artifact Enable the Cardiac
Artifact alarm.
SpO default settings
2
Select Monitor Setup > Main Setup > Parameter Setup > Page 1 > SpO2 > Setup > Page
1 or Page 2 to adjust these settings for the current patient. The following table lists the
factory default settings.
Setting Description
Scale Select the waveform
display scale.
GE TruSignal
technology only.
Size
Select the waveform
display size. Nellcor
and Masimo SET
technologies only.
Hemo Sweep Select the waveform
Speed
display sweep
speed.
Averaging
Select the averaging
time. GE TruSignal
and Masimo SET
technologies only.
Primary HR Select the parameter
Source
to calculate HR.
Show Pulse Rate Enable the pulse rate
display.
Beat Volume Select the volume of
the pulse rate beat
tone.
Beat Source
Select what is used
as the beat source.
Variable Beat Select what is used
Tone Source as the variable beat
tone source.
Show Sat. Enable SatSeconds
Seconds display. Nellcor
technology only.
356
ED
ICU NICU
40/4 75/20
Alarm On
ED ICU NICU
AUTO
25 mm/s
GE TruSignal technology: 12 s (Perfusion profile: 5 s)
Masimo SET technology: 8 s
AUTO
Disabled
0
Primary HR
Disabled
CARESCAPE ONE
OR PACU
40/OFF 40/4
(Perfusion
profile:
OFF/OFF)
20
OR PACU
1x
5
Off
2094480-001
0