Alarm Priorities And Escalation Times For Spo - GE CARESCAPE ONE User Manual

CARESCAPE ONE User Manual DRAFT 26 October 2017
MESSAGE NOTES
Lead I failed
●
Lead II failed
●
Lead RL-LL
●
failed
Measurement off
OFF
Measurement
paused
Resp (Imped.)
measurement
paused
Relearning
RR (Imped.) high Alarm priority set
/ RR (Imped.) low to Escalating
RR (Imped.) high Alarm priority
/ RR (Imped.) low set to info, low,
medium or high

Alarm priorities and escalation times for SpO

The following table shows the messages with their priorities and escalation times. In the
table, the message location is indicated by the following: alarm = alarm area; param. =
parameter window; and wavef. = waveform area. In the following table, 0 s = no intended
delay. For more information on alarm messages, refer to the user information provided.
MESSAGE NOTES
Artifact GE TruSignal,
Masimo
Check device
Check probe
Check SpO2
probe
Expiring cable Masimo
Masimo
Expiring probe
Faulty probe
Identical SpO2
device
2094480-001
LOCATION PRIORITIES AND ESCALATION TIMES
info
param.,
0 s
wavef.
param.
● 0 s
wavef.
●
wavef.
●
alarm
●
param.,
0 s
wavef.
alarm
alarm High, medium, low, or info according to priority setting.
The alarm delay is equivalent to the set respiration
rate alarm delay, which is configurable from 0 to 20 s
in increments of 5 s.
LOCATION PRIORITIES AND ESCALATION TIMES
info
param.
0 s
param.
0 s
param.
0 s
alarm
param.
0 s
param.
0 s
param.
0 s
alarm
CARESCAPE ONE
Alarm specifications
low medium
X + 20 s
X seconds
(X =
adjustable
limit)
X + 20 s
X seconds
(X =
adjustable
limit)
2
low medium
5 s 30 s
0 s
high
X + 40 s
X + 40 s
high
279