CARESCAPE ONE User Manual DRAFT 26 October 2017
Setting up the monitor before use
Normal screen and other pages
When monitoring begins, the main page appears automatically. This preconfigured
page is called the normal screen. Any changes you make to the screen setup during
monitoring are changes to this normal screen. These changes are not permanent
unless they are saved to a profile. They are valid until the case is reset/the patient is
discharged. They are also kept in the device memory for 2 hours after the power
is turned off.
A second page is available to display measured parameters that do not fit on page 1
of the normal screen. Simply swipe the touchscreen with your finger to move back
and forth between the pages.
Selecting the normal screen (main page)
You can return to the normal screen (main page) any time during monitoring.
1. Select
Adjusting sound volumes
You can adjust various sound volumes according to your care environment needs.
While you are adjusting the volume, you will hear a corresponding sound that will
guide you in determining a suitable level. All volumes other than Alarm Volume can be
set to 0 if required.
1. Select Monitor Setup > Main Setup.
2. Select Sound Volumes.
3. Adjust the different sound volumes:
Alarm Volume
●
Beat Volume
●
Completed NIBP Volume
●
Touch Volume. This selection is not adjustable if it has been locked.
●
Brightness settings
Adjusting the display brightness
You can set the display brightness level according to your needs.
2094480-001
twice.
CARESCAPE ONE
5
61