Turning Inspiration And Expiration Markers On Or Off; Selecting The Waveform Speed; Relearning The Respiration Pattern; Turning On Or Off The Respiration Rate Alarm - GE CARESCAPE ONE User Manual

CARESCAPE ONE User Manual DRAFT 26 October 2017
2. Select Setup > Page 2.
3. Select the Imped. Resp Smoothing check box to enable smoothing. Deselect it
to disable smoothing.

Turning inspiration and expiration markers on or off

You can select whether or not the inspiration and expiration markers are displayed on
the respiration waveform.
1. Select the impedance respiration parameter window.
2. Select Setup > Page 2.
3. Select the Insp./Exp. Markers check box to turn the inspiration and expiration
waveform markers on. Deselect it to turn them off.

Selecting the waveform speed

1. Select the impedance respiration parameter window.
2. Select Setup > Page 2.
3. Select a value from the Sweep Speed list.
The lower the value, the slower the sweep speed.

Relearning the respiration pattern

If the patient's breathing pattern changes after the initial learning process has taken
place, it may be necessary to relearn. There is no respiration rate displayed during the
relearning process. When relearning is complete, the Relearning message will clear
and the respiration rate will be displayed.
1. Select the impedance respiration parameter window.
2. Select Setup > Page 1.
3. Select Relearn Respiration.
The detection threshold (sensitivity) and the waveform size update after the new
respiration pattern is learned.

Turning on or off the respiration rate alarm

1. Select the impedance respiration parameter window.
2. Select the Alarms tab.
3. Select the Alarm On check box to turn the alarm on for Resp Rate (Imped.).
Deselect it to turn the alarm off.
If you deselect Alarm On, you cannot adjust the alarm limits.
The delays for respiration rate high and low alarms are configurable from 0 to 30
seconds in increments of 5 seconds. For more information, see the supplemental
information provided.

Setting the respiration alarm limits

1. Select the impedance respiration parameter window.
2. Select the Alarms tab.
2094480-001 CARESCAPE ONE
Impedance respiration
129