Electrical Wiring - INVT Goodrive350 Series Operation Manual

Communication extension card
LED
LED3
(System fault
indicator)
LED4
(Slave ready indicator)
LED5
(Maintenance state
indicator)
LED6/7
(Network port state
indicator)
LED8/9
(Network port
communication
indicator)

4.3 Electrical wiring

PROFINET communication card provides standard RJ45 ports and supports the linear
network topology and star-shaped network topology. Figure 4-2 and Figure 4-3 show the
electrical wiring diagrams.
Master
station
device
Figure 4-2 Electrical wiring diagram of the linear network topology
Note: For the star-shaped network topology, you need to use a PROFINET switch.
Color State
On
Red
Off
On
Green Blinking
Off
Green
On
Green
Off
On
Green
Off
Slave station
device 1
RJ45 RJ45
RJ45
PROFINET communication card
PROFINET diagnosis enabled
PROFINET diagnosis disabled
TPS-1 communication stack started
TPS-1 waits for the initialization of MCU
TPS-1 communication stack not started
Defined by the manufacturer, depending
on the characteristics of the device
PROFINET
connected to the PC/PLC through a
network cable
PROFINET
connected to the PC/PLC
PROFINET
communicating with the PC/PLC
PROFINET
communicating with the PC/PLC
Slave station
device 2
RJ45
-47-
Description
communication
communication card
communication
communication card
Slave station
device n
RJ45
RJ45
card
not
card
not