Configuration And Parameterization With E!Cockpit; Configuration And Parameterization Via Gsd File; 750-489 (4Ai Rtd/Tc/Strain Gauge Ex I) Configuration; Profibus Dp Fieldbus Couplers/Controllers 750-333(/0Xx-000), 750-833(/0Xx-000) - WAGO 750-489 Manual

140 Commissioning
7.2 Configuration and Parameterization with
e!COCKPIT
The 750-489 I/O module is supported by the e!COCKPIT commissioning tool
4
starting with version 1.7.0.0 – see manual "2759-0101 e!COCKPIT," Section
"Operating."
7.3

Configuration and Parameterization via GSD File

The I/O module can also be parameterized via PROFIBUS and PROFINET
device description (GSD file).
Behavior after Overwriting with WAGO-I/O-CHECK !
If WAGO-I/O-CHECK is used to overwrite a parameterization made with the
GSD file, the I/O module operates with the WAGO-I/O-CHECK settings until the
750-333 and 750-833 Fieldbus Couplers/Controllers are restarted.
After restart, the I/O module is re-parameterized via PROFIBUS using the GSD
settings.
7.3.1

750-489 (4AI RTD/TC/Strain Gauge Ex i) Configuration

7.3.1.1 PROFIBUS DP Fieldbus Couplers/Controllers 750-333(/0xx-000),
750-833(/0xx-000)
When the aforementioned PROFIBUS DP fieldbus devices are used, the process
image size is configured by selecting the corresponding GSD entry.

Table 145: PROFIBUS DP Configuration

GSD Entry
Module
750-489 4AI RTD/TC/Strain
Gauge Ex i
750-489 4AI RTD/TC/Strain
Gauge Ex i RA
PFC 750-489 4AI RTD/TC/Strain
Gauge Ex i
1) Only available with 750-833(/0xx-000)
Manual
Version 1.1.0, valid from FW Version 02
Sub
Module
1)
750-489 4AI RTD/TC/Strain Gauge Ex i
PA Length/
[Byte]
I O
8 n/a
n/a 12 12
n/a n/a
WAGO-I/O-SYSTEM 750
Data Type Inst.
INT16
{UINT8, INT16}
n/a n/a
4