Inserting And Removing Devices; Inserting The I/O Module; Figure 11: Inserting I/O Module (Example); Figure 12: Snap The I/O Module Into Place (Example) - WAGO 750-489 Manual

WAGO-I/O-SYSTEM 750
750-489 4AI RTD/TC/Strain Gauge Ex i
5.2

Inserting and Removing Devices

5.2.1

Inserting the I/O Module

1. Position the I/O module in such a way that the groove and spring are
connected to the preceding and following components.

Figure 11: Inserting I/O Module (Example)

2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 12: Snap the I/O Module into Place (Example)

3. Check that the I/O module is seated securely on the carrier rail and in the
assembly. The I/O module must not be inserted crooked or askew.
Version 1.1.0, valid from FW Version 02
Mounting 109
Manual