Removing The I/O Module; Figure 13: Removing The I/O Module (Example) - WAGO 750-489 Manual

110 Mounting
Once the I/O module has snapped into place, the electrical connections for the
data contacts and power contacts (if any) to the head station or to the preceding
and, if applicable, following I/O module are established.
5.2.2

Removing the I/O Module

1. Remove the I/O module from the assembly by pulling the release tab.

Figure 13: Removing the I/O Module (Example)

Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Manual
Version 1.1.0, valid from FW Version 02
WAGO-I/O-SYSTEM 750
750-489 4AI RTD/TC/Strain Gauge Ex i