Table of Contents
Advertisement
To Install the Module
Slide the cards above the slots for the module about halfway out of
1
the mainframe.
If the module consists of a single card, then slide the module
2
approximately halfway into the mainframe.
If the module consists of more than one card, then perform the
following steps:
Slide the card approximately three inches into the mainframe.
a
Connect the appropriate interface cable (long or short) to the
b
appropriate side of the card (see illustration on page 13-4). Repeat
steps a and b for the remaining cards.
Slide the complete module into the mainframe, but not completely in.
3
Each card in the instrument is firmly seated and tightened one at a time in
step 5.
Position all cards and filler panels so that the endplates overlap.
4
Installation and Service
To Install the Module
13–7
Advertisement
Table of Contents
