Table of Contents
Advertisement
Probing
Probing Accessories
Calibration Pod
The calibration pod is only included in the Accessory Kit for the master card.
You use the calibration pod during the master and expander card skew
adjust. For complete skew adjust information, refer to the optional Agilent
Technologies 16517A/18A Service Guide, available from your Agilent
Technologies Sales Office. Information on adjusting skew is also available in
chapter 10, "Skew Adjust."
Calibration pod
16517-63201
BNC to SMB Cable Adapter
On the back of the 16517A master card there are two SMB connectors used
for external ECL arm in/out signals. Use this adapter between the BNC cable
and the analyzer. The adapter cable is only included in the Accessory Kit for
the master card.
BNC to SMB adapter
16517-61604
2–8
Advertisement
Table of Contents
