Skew Adjust And Performance Verification Messages - Agilent Technologies 16517A User Reference

Error Messages

Skew Adjust and Performance Verification Messages

Skew Adjust and Performance Verification Messages
The following Error, Warning, and Advisory messages may be encountered
when performing the skew adjust or performance verification testing. Error
messages have a red background and indicate that the measurement, or part
of the measurement, will not occur until the problem is fixed. Warning
messages have a yellow background, and indicate that the measurement, or
part of the measurement may be at risk if the operation is not understood.
Error Messages
Measurement Did Not Complete. The user was adjusting skew or
running a PV test that did not complete as it should have.
Could not complete fine deskew. The calibration was unable to
complete the fine cal binary search.
Could not complete coarse deskew. The calibration was unable to
find the high and low values needed by the fine cal binary search.
Could not start deskew. The calibration was unable to make the first
acquisition needed to start the coarse cal.
Deskew Failed!. The calibration did not find valid numbers.
Unable to find the leading/trailing edge. The clock deskew cannot
identify the leading (rising clock) or trailing edge (falling clock).
get_acckdly_bits() failed. The second clock offset cannot be set to
the desired value.
11–8