Table of Contents
Advertisement
Markers and Stop Measurements
X-pat / O-pat Occurrence Fields (Waveform menu)
X-pat / O-pat Occurrence Fields (Waveform menu)
The X-pat and O-pat occurrence fields are used to set which pattern
occurrence the marker is placed on. Occurrence counter range is from
−131071 to +131071. The reference point from which the occurrence
counter starts searching is either the trigger point, the start of the trace, or in
the case of the O marker, the X marker. If a negative number is set, the
analyzer will search backwards in time.
Center Screen Field (Waveform and Chart)
The Center Screen field accessed a selection pop-up with choices of where to
place the marked points of the waveform relative to center screen.
About Trigger This choice will position the point of the waveform
where the trigger occurred at center screen.
About X Marker This choice adjusts the delay to position the point of
the waveform where the X-Marker is placed at center screen.
About O Marker This choice adjusts the delay to position the point of
the waveform where the O-Marker is placed at center screen.
About X & O This choice adjusts the sec/Div and delay to allow both
the X and O markers to be displayed simultaneously.
X to O Display Field (Waveform and Chart)
Using pattern markers, the X to O display field only appears in the Waveform
and Chart menus. The X to O display field shows the time between the X and
O pattern markers.
9–7
Advertisement
Table of Contents
