Connecting The Router To A Configuration Pc; Router Configuration Prerequisites - MB Connect Line mbNET MDH810 Manual

8.2

Connecting the router to a configuration PC


Before configuring the router, connect it to the computer using the
crossover cable supplied (1). To do this, connect one end of the cable
to the router port labeled LAN, and the other end to your computer's
network card.

Router configuration prerequisites

9.
 a PC with a network card
 an Internet browser (HTML5-compatibility)
 The required settings on your PC are as follows:
o
the computer's IP address must be set to
192.168.0.X
o
the subnet mask must be
For instructions on how to create the required settings on a PC, please see the
next page. If you already know how to set the IP address and subnet mask, set
them as described above and then proceed with configuration as described in
Initial Configuration
Page 22 of 226
Version: 3.3.5 – DR05 – 23.03.2017
where X is variable
255.255.255.0
Die Vorgehensweise, wie Sie die erforderlichen
Einstellungen an einem PC durchführen, entneh-
men Sie bitte der folgenden Seite. Falls Ihnen die
Vorgehensweise zur Einstellung der IP-Adresse
und der Netzmaske bereits bekannt ist, stellen Sie
diese wie oben beschrieben entsprechend ein und
fahren Sie fort mit der Konfiguration in Kapitel
Erste Konfiguration