MB Connect Line mbNET MDH810 Manual page 67

Label
Enable
Auto config
Local IP address or Range
Remote IP address or
Range
Give DNS address to the
client
Encryption
Authentication
 Save your changes by clicking Save Changes.
 Finally, to save your changes permanently to the rout-
er, click Apply Changes.
To enable the connection, check the box by clicking on it.
If you select "yes" here, the PPTP server will be configured using the mbNET's LAN ad-
dress. This setting needs to be tried out first. You should only enter your PPTP server set-
tings manually if there is an address conflict.
Enter any local address in this input field.
In the example it is: 192.168.10.100
Note:
You can also use the router's LAN IP address. You should only re-host your PPTP server
in a different address space if there is an address conflict.
Enter the remote addresses here.
In the example: 192.168.10.160-170
This assigns the IP addresses of the connected clients within the range of 192.168.10.160
– 192.168.10.170.
Important It is essential that the address or address range entered here is in the same
address space as the local IP address chosen above
Enter the DNS server address.
In this case: 192.168.0.100 (router IP address)
Use the default setting (MPPE V2 All)
Use the default setting (via CHAP and MS-CHAP V2).
Description
Version: 3.3.5 – DR05 – 23.03.2017
Page 67 of 226