Mpi/Profibus Interface - MB Connect Line mbNET MDH810 Manual

Serial interfaces (continued)
Label
Configuration options for COM1 interface
COM 1
The settings that follow it apply only to this interface.
Use this drop-down field to set the interface type for COM1. The options are as follows:
Interface Type
RS232, RS485 2-wire, RS485 4-wire, RS422
Driver from list: Select a product/brand-specific driver to control your serial device.
User settings: If no suitable driver is available or you need to enter your own configuration
parameters. These can be entered manually.
Drivers
Select the driver that you want to load. Device drivers can be selected for the following
brands:
AllanBradley, AMK, ASB, AtlasCopco, Baumüller, Berger, Bosch, B&R, DanfossVLT, Elau, F-
Tron,GE_Fanuc, Hitachi, I-for-T, Indramal, IQ2000, KEB; Kuhnke, KEB, Lauer, Lenze, Locon,
Driver
Micro_Innovation, Mitshubishi, Möller, Motoman, Npos, Omron, Parker Hauser CompaxC3,
Phoenix, Pilz, PLC Direct, Primo, Proface, Promicon, Quin, SCS Automata, Seidel Kollmor-
gen, SEW, Siemens, Stoeber, Stromag, Sütron, Tsx37, Tsx47, Tsx57, Vectron, Vega Sensor,
Voelkel Grenzlastregler, Winloc
Protocol Select the protocol for communicating with the connected device. Options are: TCP and UDP
Port Enter the port that will be used for communication.
Enable ports
Checking this box means that you can access the serial devices via the public address
through fire-
through the port assigned above, without being blocked by the firewall.
wall
17.2.1

MPI/PROFIBUS Interface

Page 136 of 226
Version: 3.3.5 – DR05 – 23.03.2017
Baud rate: Enter the baud rate for communication here.
Data format: Select one of the settings for data bits, parity or stop bits
Handshake: Select a handshake (flow control) option.
Receive loops: This is a start counter for serial signals, i.e. how many cycles the sys-
tem goes through until it sends the data packet.
Description