MB Connect Line mbNET MDH810 Manual page 203

Label
Shows the user who dialed into the router via modem. The IP address of the PPP server
Modem- and PPP client (remote station) is displayed when a dial-up connection is successfully es-
Connection tablished. The connections are always incoming connections. An active connection is in-
dicated by a green dot.
Information from Shows the connection time and the number of bytes sent and received during the most
the last connection recent connection as long as the router was not restarted or switched off in the interim.
Modem Com- This input field can be used to issue a command directly to the internal modem. This
mands function should only be used as directed by MB Connect Line support personnel.
Systemloggings
Shows the type of connection and the assigned IP and DNS addresses.
Shows the commands sent to the modem to initialize it and the status of the connection
Modemloggings
process. The error messages that occur when establishing the connection are also dis-
played here.
Manual Control of You can use this button to restart the internal modem. This function should only be
the GSM modem used as instructed by MB Connect Line support personnel.
Specifies the current network availability in percent and dBm. If you have an mbNET with
Signal Quality mobile broadband and UMTS, the device will automatically change networks when UMTS
becomes available again or UMTS is no longer available.
Shows the respective transmission method. The following are possible:
GSM
service
Shows the current mobile broadband provider (T Mobile Germany as shown in Figure
Provider
211).
SIM card SIM1 Shows the status of your SIM card in mbNET.
GSM Modemlog-
Shows all events and errors related to the GSM modem.
gings
□
GSM/GPRS
□
EDGE
□
UMTS
Description
Version: 3.3.5 – DR05 – 23.03.2017
Page 203 of 226