Lan>Wan - MB Connect Line mbNET MDH810 Manual

18.3 LAN>WAN
This setting governs the outgoing data traffic, i.e. the following settings only apply to outgoing da-
ta traffic.
Label
Enable Check the box by clicking it to enable the subsequent settings after they are saved.
The following options are available for selection:
Drop: If this option is selected, it means that no data packets can pass. The sender is not no-
tified about the whereabouts of the data packets.
Action
Reject: If this option is selected, the data packets are rejected. The sender is notified that the
data packets have been rejected.
Accept: If this option is selected, the data packets can pass.
Enter the IP of a computer from which data packets are sent to the Internet here.
Source IP
If you leave the field blank, the set action applies to all IP addresses.
Source Port Enter the port via which the data packets go to the Internet here.
The following options are available for selection:
All: The set rule applies to all protocols.
Protocol tcp: The set rule only applies to the TCP protocol.
udp: The set rule only applies to the UDP protocol.
icmp: The set rule only applies to the ICMP protocol (ping).
This setting defines the WAN interface to which the rule is to be applied. „Internet" or „WAN
WAN interface
Ethernet" can be selected.
Destination IP
Enter the destination address of the data packets on the Internet here.
Destination
Enter the port via which the data packets are sent to the destination IP here.
Port
Edits the settings in the current line.
Deletes entries in the current line.
Accepts the new rule and temporarily stores it.
Temporarily saves the created rule.
Changes the order of the created rules.
Description
Page 155 of 226
Version: 3.3.5 – DR05 – 23.03.2017