Programmable Rotation (Rot, Arot, Rpl) - Siemens SINUMERIK 828D Programming Manual

Coordinate transformations (frames)

12.4 Programmable rotation (ROT, AROT, RPL)

12.4 Programmable rotation (ROT, AROT, RPL)
Function
ROT
geometry axes X, Y, Z or through an angle RPL in the selected working plane G17 to G19
(or around the perpendicular infeed axis). This allows inclined surfaces or multiple workpiece
faces to be machined in one setting.
Syntax
ROT X... Y... Z...
ROT RPL=...
AROT X... Y... Z...
AROT RPL=...
Note
Each frame operation is programmed in a separate NC block.
Significance
ROT
RPL
AROT
X... Y... Z...
364
/ can be used to rotate the workpiece coordinate system around each of the three
AROT
: Absolute rotation, with reference to the currently valid workpiece zero
set with G54 to G57, G505 to G599.
: Rotation in the plane: Angle through which the coordinate system is
rotated (plane set with G17 to G19)
The sequence in which the rotation is to be performed can be speci-
fied via the machine data. The default setting is RPY notation (= Roll,
Pitch, Yaw) with Z, Y, X.
: Additive rotation in relation to the currently valid set or programmed
zero point
: Rotation in space: Geometry axes around which the rotation is
performed
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Fundamentals