Withdrawing The Enable For The Axis Container Rotation (Axctswec) - Siemens SINUMERIK 840D sl Function Manual

Detailed description
3.7 Actions in synchronized actions
3.7.15

Withdrawing the enable for the axis container rotation (AXCTSWEC)

Function
Using the command AXCTSWEC an already issued enable signal to rotate the axis container
can be withdrawn again. The command triggers a preprocessing stop with reorganization
(STOPRE).
The following conditions must be fulfilled so that in the channel, the enable signal to rotate the
axis container is withdrawn again:
● In the channel, the axis container rotation must already have been enabled:
– AXCTSWE(<container>)
– $AC_AXCTSWA[<container>] == 1
● Axis container rotation was still not started:
– $AN_AXCTSWA[<container>] == 0
As feedback signal for the successful withdrawal of the enable signal, the following channel-
specific system variable is reset:
$AC_AXCTSWA[<container>] == 0
For a detailed description of the system variables, refer to:
References:
Parameter Manual System Variables
Syntax
DO AXCTSWEC(<container>)
Meaning
AXCTSWEC:
<Container>:
Example
Program code
; Initialization of the global counter for the technology cycle CTSWEC
92
Withdrawing the enable for the axis container rotation for the channel
Name of axis container:
Possible data include:
● CT<container number>:
The number of the axis container is attached to the CT letter combination.
Example: CT3
● <container name>:
Individual name of the axis container set using
MD12750 $MN_AXCT_NAME_TAB. Example: A_CONT3
● <Axis name>:
Axis name of a container axis known in the channel.
Comment
Function Manual, 08/2018, 6FC5397-5BP40-6BA2
Synchronized actions