Siemens SINUMERIK 828D Programming Manual page 184

Geometry settings
8.3 Dimensions
Significance
DIAMON
DIAM90
DIAMOF
DIAMCYCOF
Note
With
diameter. This also applies to reading of actual values in the workpiece coordinate system
with
184
: Command for the activation of the independent channel-specific diameter
programming
The effect of
(absolute dimensions
• for G90:
• for G91:
: Command for the activation of the dependent channel-specific diameter
programming
The effect of
• for G90:
• for G91:
: Command for the deactivation of the channel-specific diameter
programming
Channel-specific radius programming takes effect when diameter
programming is deactivated. The effect of
programmed dimensions mode:
• for G90:
• for G91:
: Command for the deactivation of channel-specific diameter programming
during cycle processing.
In this way, computations in the cycle can always be made in the radius.
The last G function active in this group remains active for the position
indicator and the basic block indicator.
or , the transverse-axis actual values will always be displayed as a
DIAMON DIAM90
, , and
MEAS MEAW $P_EP[x]
is independent of the programmed dimensions mode
DIAMON
or incremental dimensions
G90
Dimensions in the diameter
Dimensions in the diameter
depends on the programmed dimensions mode:
DIAM90
Dimensions in the diameter
Dimensions in the radius
Dimensions in the radius
Dimensions in the radius
.
$AA_IW[x]
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
):
G91
is independent of the
DIAMOF
Fundamentals