Siemens SINUMERIK 828D Programming Manual page 561

22. Alarms
Keyword / 1st
subroutine parameter
identifier
SETAL INT: Alarm
number
(cycle
alarms)
23. Compensation
Keyword / 1st parameter-
subroutine 4th parameter
identifier
QECLRNON AXIS: Axis number
QECLRNOF
24. Tool management
Keyword / 1st parameter
subroutine
identifier
DELT STRING[32]: Tool
designation
GETSELT VAR INT:
T number (return
value)
SETPIECE INT: Count
SETDNO INT: Tool number T INT: Tool
DZERO
DELDL INT: Tool number T INT: D no.
SETMTH INT: Tool-holder
no.
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
2nd Explanation
parameter
STRING: Set alarm: Sets alarm. A character string with up to four parameters can be
Character specified in addition to the alarm number.
string
The following predefined parameters are available:
%1 = channel number
%2 = block number, label
%3 = text index for cycle alarms
%4 = additional alarm parameters
2nd parameter 3rd para-
INT: Duplo
number
INT: Spindle
number
INT: Spindle
number
edge no.
Explanation
Quadrant error compensation learning ON: Quadrant error
compensation learning ON
Quadrant error compensation learning OFF: Quadrant error
compensation learning OFF
meter
INT: D no.
16.5 Predefined subroutine calls
Explanation
Delete tool. Duplo number can be
omitted.
Get selected T number. If no spindle
number is specified, the command
for the master spindle applies.
Takes account of set piece number
for all tools assigned to the spindle.
If no spindle number is specified, the
command for the master spindle
applies.
Set D no. of tool (T) and its tool
edge to new.
Set D numbers of all tools of the TO
unit assigned to the channel to
invalid
Delete all additive offsets of the tool
edge (or of a tool if D is not
specified).
Set toolholder no.
Tables
561