Siemens SINUMERIK 828D Programming Manual page 549

Group 55: Rapid traverse with/without linear interpolation
G function No.
1)
RTLION 1.
RTLIOF 2.
Group 56: Inclusion of tool wear
G function No.
1)
TOWSTD 1.
TOWMCS 2.
TOWWCS 3.
TOWBCS 4.
TOWTCS 5.
TOWKCS 6.
Group 57: Corner deceleration
G function No.
1)
FENDNORM 1.
G62 2.
G621 3.
Group 59: Dynamic response mode for path interpolation
G function No.
1)
DYNNORM 1.
DYNPOS 2.
DYNROUGH 3.
DYNSEMIFIN 4.
DYNFINISH 5.
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Significance
Rapid traverse motion with linear interpolation ON
Rapid traverse motion with linear interpolation OFF
Rapid traverse motion is achieved with single-axis
interpolation.
Significance
Initial setting value for offsets in tool length
Wear values in the machine coordinate system
Wear values in the workpiece coordinate system
Wear values in the basic coordinate system (BCS)
Wear values in the tool coordinate system (toolholder
ref. point T at the tool holder)
Wear values in the coordinate system of the tool head
for kinetic transformation
(differs from machine coordinate system through tool
rotation)
Significance
Corner deceleration OFF
Corner deceleration at inside corners when tool
radius compensation is active (G41/G42)
Corner deceleration at all corners
Significance
Standard dynamic, as previously
Positioning mode, tapping
Roughing
Finishing
Smooth-finishing
16.4 G function groups
MD20150 W
2) 3)
+ m
+ m
MD20150 W
2) 3)
+ m
+ m
+ m
+ m
+ m
+ m
MD20150 W
2) 3)
+ m
+ m
+ m
MD20150 W
2) 3)
+ m
+ m
+ m
+ m
+ m
Tables
STD
4)
SAG MM
x
STD
4)
SAG MM
x
STD
4)
SAG MM
x
STD
4)
SAG MM
x
549