Siemens SINUMERIK 828D Programming Manual page 338

Path action
11.1 Exact stop (G60, G9, G601, G602, G603)
Significance
G60
:
G9
G601
G602
G603
Note
The commands for activating the exact stop criteria (
or
G9
Example
Program code
N5 G602
N10 G0 G60 Z...
N20 X... Z...
...
N50 G1 G601
N80 G64 Z...
...
N100 G0 G9
N110 ...
338
: Command for activation of the modal exact stop
Command for activation of the non-modal exact stop
: Command for activation of the exact stop criterion "Exact stop fine"
: Command for activation of the exact stop criterion "Exact stop coarse"
: Command for activation of the exact stop criterion "Interpolator end"
is active.
Comment
; Criterion "Exact stop coarse" selected.
; Exact stop modal active.
; G60 continues to act.
; Criterion "Exact stop fine" selected.
; Switchover to continuous-path mode.
; Exact stop acts only in this block.
; Continuous-path mode active again.
/ / ) are only effective if
G601 G602 G603
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
G60
Fundamentals