Contour Definitions: Two Straight Lines (Ang) - Siemens SINUMERIK 828D Programming Manual

Motion commands
9.9 Contour definitions
Significance
X...
Z...
ANG
Example
Program code
N10 X5 Z70 F1000 G18
N20 X88.8 ANG=110
N30 ...
or
Program code
N10 X5 Z70 F1000 G18
N20 Z39.5 ANG=110
N30 ...
9.9.3

Contour definitions: Two straight lines (ANG)

Note
In the following description it is assumed that:
• G18 is active (⇒ active working plane is the Z/X plane).
• The following identifiers have been defined for angle, radius and chamfer:
248
: End point coordinate in the X direction
: End point coordinate in the Z direction
: Identifier for the angle programming
The specified value (angle) refers to the abscissa of the active working plane
(Z axis with
G18
(However, the programming of contour definitions is also possible without restrictions with
G17 or G19.)
– ANG (angle)
– RND (radius)
– CHR (chamfer)
).
Comment
; Approach of the starting position.
; Straight line with angle specification.
Comment
; Approach of the starting position.
; Straight line with angle specification.
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Fundamentals