Siemens SINUMERIK 828D Programming Manual page 251

CHR=...
X...
Z...
Note
For further information on the programming of a chamfer or rounding, see "Chamfer,
rounding (CHF, CHR, RND, RNDM, FRC, FRCM) (Page 282)".
Example
Program code
N10 X10 Z80 F1000 G18
N20 ANG=148.65 CHR=5.5
N30 X85 Z40 ANG=100
N40 ...
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
: Identifier for the programming of a chamfer
The specified value corresponds to the width of the chamfer in the
direction of motion:
: Coordinates in the X direction
: Coordinates in the Z direction
Comment
; Approach of the starting position.
; Straight line with angle and chamfer specification.
; Straight line with angle and end point specification.
Motion commands
9.9 Contour definitions
251