Siemens SINUMERIK 828D Programming Manual page 363

Further information
The absolute translation component is modified by the following commands:
● TRANS
● G58
● CTRANS
● CFINE
● $P_PFRAME[X,TR]
The additive translation component is modified by the following commands:
● ATRANS
● G59
● CTRANS
● CFINE
● $P_PFRAME[X,FI]
The table below describes the effect of various program commands on the absolute and
additive offsets.
command
TRANS X10
G58 X10
$P_PFRAME[X,TR]=10
ATRANS X10
G59 X10
$P_PFRAME[X,FI]=10
CTRANS(X,10)
CTRANS()
CFINE(X,10)
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Coarse or Fine or additive
absolute offset offset
10 unchanged
10 unchanged
10 unchanged
unchanged fine (old) + 10
unchanged 10
unchanged 10
10 0
0 0
0 10
Coordinate transformations (frames)
12.3 Programmable zero offset
Comment
Absolute offset for X
Overwrites absolute offset for X
Progr. offset in X
Additive offset for X
Overwriting additive offset for X
Progr. fine offset in X
Offset for X
Deselection of offset (including
fine offset component)
Fine offset in X
363