Siemens SINUMERIK 828D Programming Manual page 182

Geometry settings
8.3 Dimensions
Further information
G70/G71
With
system:
● Position data (
● Circular-path programming:
● Pitch (
● Programmable zero offset (
● Polar radius (
Synchronized actions
If, in a synchronized action (condition component and/or action component) no explicit
measuring system is programmed (
active in the channel at the point of execution will be applied to the synchronized action
(condition component and/or action component).
NOTICE
Read position data in synchronized actions
If a measuring system has not been explicitly programmed in the synchronized action
(condition component and/or action component) position data specified in units of length in
the synchronized action are always read in the parameterized basic system.
References
● Function Manual, Basic Functions; Speeds, Setpoint/Actual-Value System, Closed-Loop
● Programming Manual, Job Planning; Section "Motion-synchronous actions"
● Function Manual, Synchronized Actions
182
/ active, only the following geometric data is interpreted in the relevant measuring
G70 G71
, , , ...)
X Y Z
– Interpolation point coordinates (
– Interpolation parameters (
– Circle radius ( )
CR
, )
G34 G35
)
RP
Control (G2), Section "Metric/inch dimension system"
, , )
I1 J1 K1
, , )
I J K
)
TRANS
/ / /
G70 G71 G700 G710)
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
, the measuring system which was
Fundamentals