Siemens SINUMERIK 828D Programming Manual page 377

ASCALE X... Y... Z...
The
this case, the last valid scale factor is multiplied by the new one.
The currently set or last programmed coordinate system is used as the reference for the
scale change.
Scaling and offset
Note
If an offset is programmed with
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
command is used to program scale changes to be added to existing frames. In
ASCALE
TRANS
12.6 Programmable scale factor (SCALE, ASCALE)
AROT
after , the offset values will also be scaled.
ATRANS SCALE
Coordinate transformations (frames)
377