Several Feedrate Values In One Block (F, St, Sr, Fma, Sta, Sra) - Siemens SINUMERIK 828D Programming Manual

7.10

Several feedrate values in one block (F, ST, SR, FMA, STA, SRA)

Function
The "Multiple feedrates in one block" function can be used to activate different feedrate
values for an NC block, a dwell time or a retraction motion-synchronously, dependent on
external digital and/or analog inputs.
The HW input signals are combined in one input byte.
Syntax
F2=... to F7=...
ST=...
SR=...
FMA[2,<axis>]=...
STA[<axis>]=...
SRA[<axis>]=...
Significance
F2=... to F7=...
ST=...
SR=...
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
7.10 Several feedrate values in one block (F, ST, SR, FMA, STA, SRA)
to
FMA[7,<axis>]=...
:
:
:
The path feedrate is programmed under the
address and remains valid during the
F
absence of an input signal.
In addition to the path feedrate, up to 6
further feedrates can be programmed in the
block. The numerical expansion indicates the
bit number of the input that activates the
feedrate when changed:
Effective: non-modal
Dwell time in s (for grinding technology:
sparking-out time)
Input bit: 1
Effective: non-modal
Retraction path
The unit for the retraction path refers to the
current valid unit of measurement (mm or
inch).
Input bit: 0
Effective: non-modal
Feed control
149