Siemens SINUMERIK 828D Programming Manual page 137

Further information
FA[...]
The feedrate type is always
to the default setting in the machine data.
program.
NOTICE
If no
FPR(...)
As an extension of the
FPR
FPR(...)
If the rotary axis/spindle specified in the FPR command is operating on position control, then
the setpoint linkage is active. Otherwise the actual-value linkage is effective.
FPRAON(...)
FPRAON
current feedrate of another rotary axis or spindle.
FPRAOF(...)
The revolutional feedrate can be deactivated for one or a number of axes/spindles
simultaneously with the
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
7.5 Feedrate for positioning axes/spindles (FA, FPR, FPRAON, FPRAOF)
is programmed, the value defined in the machine data applies.
FA
command (revolutional feedrate referring to the master spindle),
G95
allows the revolutional feedrate to be derived from any chosen spindle or rotary axis.
is valid for path and synchronized axes.
is used to derive the revolutional feedrate for positioning axes and spindles from the
FPRAOF
. When / is active, the unit is metric/inches according
G94 G70 G71
/
G700 G710
command.
can be used to modify the unit in the
Feed control
G95
137