Performing Tests
10.3
Performing Tests
10.3.1
Protective Earth Resistance
General Information
Connect the measurement tip of your measuring device with the conductive parts shown in the
table below and measure the resistance.
If a test does not pass, device must be repaired by Brainlab support. After repair, repeat the entire
electrical safety test from the beginning.
Protective Earth Resistance
Point Tested
Potential equalization port
Display fixation screw
Second display fixation
screw
150
System and Technical User Guide Rev. 1.0 Curve Dual Navigation Station Ver. 1.2
Measured Value
Test
Passed?