Configuration And Operation; Initial Start-Up; Controls - Kaco blueplanet 87.0 TL3 Manual

9

Configuration and operation

9.1

Initial start-up

NOTE
The DC power supply must be guaranteed during initial start-up.
The sequence of the settings required for initial start-up is preset in the configuration assistant.
9.2

Controls

The 3 LEDs on the device show the different operating states. The LEDs can display the following states:
LED illuminated
Operating status
Start
Feed-in start
Feed-in operation with re-
duced power
Non-grid feed mode
Error
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
KACO blueplanet 137 TL3 KACO blueplanet 150 TL3
LED flashing
LED Icon Description
The green "Operating" LED is illuminated when AC and DC voltage is
present.
If the LED is flashing, the internal communication between the compon-
ents is established. After flashing, the device is ready for feed-in.
If the LED continues to flash permanently, the internal communication is
interrupted.
The green "Operating" LED is lit.
The green "Feed-in" LED is illuminated after the country-specific wait-
ing period*.
The device feeds into the grid.
The interface switch engages audibly.
The green "Operating" LED is lit.
The green LED "Feed" is flashing because one of the modes: internal
power reduction, external power reduction, idle power request or stan-
dalone mode is active.
The device feeds into the grid.
The interface switch engages audibly.
The green "Operating" LED is lit.
No LED is lit.
Error on the device or AC/DC source
LED not illuminated
Page 43