Kaco blueplanet 87.0 TL3 Manual page 36

Step 1: Language selection
↻ The installation wizard has been started or re-started.
1 Select Menu language via the dropdown menu.
2 Confirm the action field.
» Pressing the Next button will take you to the next installation step.
Step 2: Country configuration
↻ A language has been selected.
1 Select Country and Grid type from the dropdown menu.
2 Confirm the action field.
» Pressing the Next button will take you to the next installation step.
Step 3: Network parameters
↻ The country and grid type have been selected.
NOTE: By default, IP addresses are assigned via the plant DHCP server.
NOTE: If static IP addresses are required, you will have to assign these.
CAUTION! In this case, it is no longer possible to distribute the configuration
via the Segment Controller as this would then be part of the configuration and
ultimately all inverters in the same segment would be assigned the same IP
address.
1 Activate DHCP or enter the IP address at the deactivated DHCP.
2 Confirm the action field.
» The Forward button jumps to the next installation step.
Step 4: Localisation
↻ Network parameters have been set.
1 Set Date, time and time zone or initiate synchronisation with the client.
2 NOTE: The synchronisation requires the activation of an NTP server
3 Select temperature unit via the dropdown menu.
4 Confirm the action field.
» The Forward button jumps to the next installation step.
Step 5: Cloud & portal configuration
↻ Localisation has been carried out.
1 If available, activate Web portal and select Portal from the dropdown
menu.
2 Configure the portal.
3 Confirm the action field.
» The Forward button jumps to the next installation step.
8
It is preferable to install this on a plant component. It is also possible to select an NTP server localized on the internet
provided the device has direct access to the internet.
Page 36 KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
Fig. 44: Menu item: Configuration
via web user interface [See sec-
tion 9.4.2} Page 48]
Fig. 45: Menu item:Configuration
via web user interface [See sec-
tion 9.4.2} Page 48]
Fig. 46: Menu item: Configuration
via web user interface [See sec-
tion 9.4.2} Page 48]
8
Fig. 47: Menu item: Configuration
via web user interface [See sec-
tion 9.4.2} Page 48]
Fig. 48: Menu item: Configuration
via web user interface [See sec-
tion 9.4.2} Page 48]
KACO blueplanet 137 TL3 KACO blueplanet 150 TL3