Replacing The Fan - Kaco blueplanet 87.0 TL3 Manual

↻ Cleaning the heat sink requires the fan to be removed.
↻ Switch off the device and secure it against restart.
↻ Keep a suitable brush ready for cleaning.
1 Remove the hood and fan Replacing the fan [See section 11.3} Page 91].
2 Clean the free space between the cover and the heat sink using suitable
brushes.
3 Clean the heat sink with a suitable brush.
NOTE: Do not use any aggressive cleaning agents and ensure that no other
components come into contact with fluids.
» Cleaning completed – if necessary, remount the fans.
11.3

Replacing the fan

Removing the cover
↻ A check has been performed to ensure there is no AC/DC voltage present.
1 Remove the fastening screws on the cover from both sides [ _T20]
2 Lift up the cover from both sides and press it out of the mounting clips.
3 Set the cover to one side.
» Proceed with the cleaning or removal of the fans.
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
KACO blueplanet 137 TL3 KACO blueplanet 150 TL3
3x
2 mm
2
Fig. 102: Cleaning the cooling fins
from above
4x
2
1
Fig. 103: Cleaning the cooling fins
from below
1 Heat sinks / space between
heat sinks
2 Brush (max. wire diameter
2mm)
4
3
2
Fig. 104: Removing the cover
1 Cover
2 Fastening screw
3 Mounting clips
4 Fans
1
1
Page 91