Fastening The Mount - Kaco blueplanet 87.0 TL3 Manual

1 Cover
2 Side section - upper
3 Clamp (4x)
↻ The device is transported to the installation location.
1 Remove the plastic band from the pallet and packaging.
2 Pull the clamp off the packaging.
3 Pull the hood upwards to remove it and place the cardboard packaging to one side together with the mount and ac-
cessories.
4 Set the unit with base and side sections upright.
5 Remove the top side section and base from the device.
» If the unit is in the correct installation position: Proceed with the installation of the mount.
6.3

Fastening the mount

CAUTION
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seri-
ously injured.
› Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are
only suitable for masonry and concrete.
› Only install the device in an upright position.
153 mm
75 mm
B
A
D
C
Fig. 16: Minimum clearances for wall mounting
Key
1 Mount
2 Fixings for mounting [S12 – Ø 12mm/ 90mm]*
3 Lock washer
A Minimum clearance: 120
Recommended clearance: 400
B Minimum clearance: 300
C Minimum clearance: 500
D Recommended clearance: 1000
↻ Cardboard packaging with mount and mounting kit removed from the packaging and opened.
Page 18
2
1
A
6
3
4
A
Detail A
5
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
4 Base
5 Side section - lower
6 Cardboard packaging with mount and mounting kit
550 mm
453 mm
458 mm
1066 mm
2)
1543 mm
1)
475 mm
1) 270 mm
1) 475 mm
1)
270 mm
Fig. 17: Wall mounting
4 Screw for mounting (4x) [SW 13 / Fastening the
mount [See section 6.3} Page 18]]
5 Screw for securing purposes (1x)
6 Bracket to store the device
1)
Minimum clearance excluding device:270
1)
Recommended clearance excluding device: 475
- -
- -
²) Recommended clearance with DC breaker: 1543
KACO blueplanet 137 TL3 KACO blueplanet 150 TL3
1
5
6