Installation; General Information; Opening The Device; Surveying The Connection Area - Kaco blueplanet 87.0 TL3 Manual

7

Installation

7.1

General information

DANGER
Lethal voltages are still present in the connections and cables of the device even after the device has
been switched off and disconnected!
Severe injuries or death may occur if the cables and/or terminals/busbars in the device are touched.
› The device must be mounted in a fixed position before being connected electrically.
› Comply with all safety regulations and current technical connection specifications of the responsible
power supply company.
› The device is only permitted to be opened or serviced by a qualified electrician.
› Switch off the grid voltage by turning off the external circuit breakers.
› Check that all AC and DC cables are completely free of current using a clip-on ammeter.
› Do not touch the cables and/or terminals/busbars when switching the device on and off.
› Keep the device closed when in operation.
↻ NOTE: S version: The device is shut down externally at the combiner box.
1 Switch the DC isolator switch from 1 (ON) to 0 (OFF).
2 Press in the safety catch (1) from behind.
3 Attach the hanging lock (2) to the safety catch.
DANGER! A measurement in a live state may be required for tests. Only appro-
priately qualified electricians authorised by the mains supply network oper-
ator are permitted to open and maintain the device.
DANGER! Observe all safety regulations against harmless contact with live ma-
terials.
7.2

Opening the device

↻ The device has been installed on the mount.
↻ Wipe any moisture off the frame of the housing cover using a cloth.
1 Undo the 6 screws and carefully remove the housing cover [ T_25]
2 Take care not to damage or soil the seals and fibre optics when setting down the
housing cover.
» Proceed with the installation of the device.
7.3

Surveying the connection area

6
5
4
Fig. 22: Connection area on DC side (left) / AC side (right)
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
KACO blueplanet 137 TL3 KACO blueplanet 150 TL3
6
5
1
4
2
3
Fig. 23: Connection area (XL - Version)
Fig. 20: Lock DC circuit breakers to
prevent reconnection.
1
2
Fig. 21: Remove housing cover
1
2
1
2
3
Page 21