General Design Data Of The Ethernet/Ip Interface - Eaton Rapid Link 5 Manual

9.2.12 General design data of the EtherNet/IP interface

Service codes
The following standard EtherNet/IP service codes are used in accordance
with the CIP Specification:
Service code Service name
0x0E Get_Attribute_Single
0x10 Set_Attribute_Single
0x4E Read_Holding_Registers
0x50 Write_Holding_Registers
0x18 Get_Member
0x19 Set_Member
Identity object 01h
The 01h identity object provides information about the EtherNet/IP module.
This includes information regarding the device name, the device version, the
serial number, and version information.
Instance attributes for the identity object 01h
Attribute Attribute name
number
1 (0x01) VENDOR
2 (0x02) DEVICE TYPE
3 (0x03) PRODUCT CODE
4 (0x04) REVISION
MAJOR
MINOR
5 (0x05) DEVICE STATUS
6 (0x06) SERIAL NUMBER
7 (0x07) PRODUCT NAME
Property
Connections
Data transfer
Transmission cable
Communication protocol
Standard
Baud rate
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
Access Data type
right
ro | rw
ro UINT
ro UINT
ro UINT
ro STRUCT of
USINT
USINT
ro WORD
ro UINT
ro SHORT STRING
Value
M12 D-coded
10/100 Mbit/s
Full-duplex/half-duplex automatic baud rate detection
Twisted two-pair balanced cable, screened
IEC 61158
10/100 Mbit/s
9 Communication
9.2 EtherNet / IP
Description
Manufacturer's code
Classifies the product as a communica-
tion adapter
Order number
Device version
Device status
Serial number of the device
Length (first byte) and product name
219