Position Of The Power Connections - Eaton Rapid Link 5 Manual

3 Installation
3.2 Instruction leaflets

3.2.4 Position of the power connections

The standard arrangement of the power connections is vertical and down-
wards.
Qualified specialists can create a horizontal arrangement by turning the black
enclosure base 90° to the left or right. To do this, remove the four screws in the
enclosure cover.
1
TORX 30 IP
Figure 44: Dismantling the enclosure cover
▶ Fix the enclosure cover at the side and lift off carefully.
87
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com