Electrical Installation; Power Bus - Eaton Rapid Link 5 Manual

3 Installation

3.3 Electrical installation

3.3 Electrical installation

3.4 Power bus

90
DANGER

Risk of injury due to electric shock!
Carry out wiring work only if the unit is de-energized.
ATTENTION

Fire hazard!
Only use cables, circuit breakers and contactors with the indica-
ted permissible nominal current value.
DANGER

The components in the RASP5 power section remain energized
up to five minutes after the supply voltage has been switched
off (internal DC-Link capacitor discharging time).
On RASP5 units, only disconnect the motor feeder cable and
only perform work on the motor terminal box after the dischar-
ging time has elapsed.
The Rapid Link 5 system can have one of two types of power bus:
• Flexible (RA-C1-7...) busbar,
• Round conductor (standard cable).
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com