Operational Warnings - Eaton Rapid Link 5 Manual

4 Operation

4.2 Operational warnings

4.2 Operational warnings
116
Please observe the following notes.
DANGER

Commissioning must only be completed by qualified technicians.
DANGER – DANGEROUS ELECTRICAL VOLTAGE!

The safety instructions on pages I and II must be followed.
ATTENTION
Before switching on the supply voltage (400 V AC) for the first
time, check that all cables are connected to the correct termi-
nals and that all PE and earth connections have been establis-
hed.
ATTENTION
For RASP5 units, the pause between two power-on operations
must be at least one minute.
DANGER

The contacts of the motor feeder sockets may be live when the
supply voltage (mains voltage) is connected.
The control signal terminals are isolated from the line power
potential.
DANGER

RAMO5 unit outputs carry a dangerous voltage whenever the
supply voltage is switched on, even if the unit is in the OFF/
STOP state.
DANGER

Do not remove the motor plug or power plug when the system
is live.
DANGER

The output to the brake carries a dangerous voltage whenever
the supply voltage is switched on - even if in the OFF state!
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com